Passat Sedan L4-1896cc 1.9L DSL Turbo (1Z) (1997)
13
Brake caliper
14
Outer wheel bearing
15
Nut
-
Adjusting wheel bearing play. Refer to Transmission and Drivetrain.
-
Secure with locking ring and a new cotter pin
16
Cotter pin
-
Always Replace
17
Grease cap
-
Removing/installing. Refer to Transmission and Drivetrain.
18
Lock ring
19
Thrust washer
20
Wheel bolt
-
Tighten to 110 Nm (81 ft lb)
21
Brake disc
-
Diameter:
FWD models: 226 mm
AWD models: 239 mm
-
Thickness, all models 10 mm (0.394 inch)
-
Wear limit 8 mm (0.315 inch)
-
When worn always replace discs on both sides
22
Inner wheel bearing
23
Seal
24
Rotor for ABS Wheel Speed Sensor
-
To drive off, insert drift through wheel bolt holes
-
Drive on with suitable sleeve
25
Bolt
-
Tighten to: 60 Nm (44 ft lb)
26
Dished washer
-
Large contact surface faces splash shield
27
Backing plate
28
Stub axle
29
Parking brake cable
30
Spring clip
Removal
NOTE: If the brake pads are to be reused, mark their installed positions before removal. Install in their original positions to avoid uneven braking.
1. Remove wheels.
2. Disconnect parking brake cable from brake caliper.
3. Remove brake caliper housing.