Passat Sedan L4-1896cc 1.9L DSL Turbo (1Z) (1997)
Can be replaced with the steering gear installed
Must not be twisted after adjusting toe
Must not be installed on a ZF power steering gear
10. Hose Clamp
11. Left-hand tie rod
70 Nm (52 ft lb)
Removing and installing See: Tie Rod/Service and Repair
Adjusting length See: Tie Rod/Adjustments
Tie rod boot seat diameter
ZF: 15mm
TRW: 12.7mm
It must not be installed on a ZF power steering gear
12. Pressure balancing tube
Check for damage
13. Right-hand tie rod
70 Nm (52 ft lb)
Removing and installing See: Tie Rod/Service and Repair
Vehicle alignment See: Alignment
Tie rod boot seat diameter
ZF: 15mm
TRW: 12.7mm
It must not be installed on a ZF power steering gear
14. Self-locking nut 30 Nm (22 ft lb)
15. Clamp
16. Rubber mountings
Internal Diameter
ZF: 50mm
TRW 44mm
Power Assisted Steering Box (ZF)
Assembly overview, power steering gear (ZF)
It is not intended that repair work be carried out on the power steering gear. If complaints are received determine cause with the help of pressure tests,
leakage test and troubleshooting programs. If a malfunction exists replace the power steering gear.
NOTE:
Always replace self-locking nuts and bolts.
Welding and straightening work on steering components is not permitted.
To grease the rack use only steering gear grease, Part No. AOF 063 000 04, or equivalent.
Type of oil: Hydraulic oil part No. G 002 000, or equivalent
Oil system capacity: 0.7-0.9 liter. (0.74-0.95 qt)
Supply and pressure line routing. See: Power Steering/Power Steering Line/Hose/Service and Repair