Passat Sedan L4-2.0L Turbo (BPY) (2007)
/Page-3786002.png)
No production change required.
Service
When installing the headliner:
Pre-assemble front/rear grab handles on both sides to headliner -1-, brackets -20- and clamps -22- using screws -13-.
Tip: Tighten screws so that assembly stays together (do not tighten to the point where clamps deform).
Left front grab handle shown pre-assembled to headliner.
-
Pre-assemble sun visors to clamp and brackets -8- and -9- using screws -4-
Tip: Tighten screws so that assembly stays together (do not tighten to the point where clamps deform).
-
Pre-assemble headliner center console with clamps and brackets as shown.
Tip: Tighten screws so that assembly stays together (do not tighten to the point where clamps deform).
Using a second technician:
