Passat Sedan L4-2.0L Turbo (BPY) (2007)
^
Locate the lumbar/seat recliner motor harness near left side seat track.
^
Disconnect the T6cs connector.
^
Pull harness back to inspect the underside of the harness.
^
Check for harness chaffing or a cut from the seat frame on the wiring harness, 2-3 inches from the T6cs connector.
^
Install a 32mm piece of protective edging Part No. 3C0971882 on the seat frame as shown, where the seat harness rests on the seat frame.
^
Repair the lumbar/seat recliner wiring using wiring harness repair set 1978A. See Electrical System, Group 97 Wiring, Electrical Equipment, General
Information, Wiring Harness Repair in ElsaWeb.
^
Reconnect and secure the T6cs connector into seat frame harness.
^
Install Seat, see Repair Manual Group 72 in ElsaWeb.
^
Reset basic settings on the seat motors.