Passat Sedan L4-2.0L Turbo (BPY) (2007)
Coolant Temperature Sensor/Switch (For Computer): Testing and Inspection
Engine Coolant Temperature (ECT) Sensor, Checking
Engine Coolant Temperature (ECT) Sensor, Checking
NOTE: Use only gold-plated terminals when servicing terminals in the harness connector.
Recommended special tools and equipment
-
V.A.G1526 multimeter or V.A.G1715 multimeter
-
V.A.G1594 connector test kit
-
Wiring diagram
Test requirements
-
Fuses on E-box in engine compartment, left side, must be OK.
NOTE: Fuses on this fuse holder are labelled "SB" in the wiring diagram.
-
Fuses on fuse holder in instrument panel, left side, must be OK.
NOTE: Fuses on this fuse holder are labelled "SC" in the wiring diagram.
-
Battery voltage must be at least 11.5 Volts.
-
Ground (GND) connections between engine and chassis must be OK.
-
All electrical consumers such as, lights and rear window defroster must be switched off.
-
Engine must be cold.
-
Ignition switched off.
Function test
Observe safety precautions.
Observe rules for cleanliness.