Passat Sedan L4-2.0L Turbo (BPY) (2007)
If the DTC does return and no malfunction is detected in the wiring and the voltage supply was not OK:
-
Replace the Transmission Control Module (TCM) (J217). Refer to => [ Transmission Control Module J217, Replacing ] See: Transmission
Control Systems/Relays and Modules - Transmission and Drivetrain/Relays and Modules - A/T/Control Module/Service and Repair.
-
Assembly is performed in the reverse of the removal.
Final Procedures
After the repair work, the following work steps must be performed in the following sequence:
1. Check the DTC memory. Refer to => [ Diagnostic Mode 03 - Read DTC Memory ] See: Testing and Inspection/Scan Tool Testing and
Procedures/Diagnostic Modes 01 - 09/Diagnostic Mode 03 - Read DTC Memory.
2. If necessary, erase the DTC memory. Refer to => [ Diagnostic Mode 04 - Erase DTC Memory ] See: Testing and Inspection/Scan Tool Testing
and Procedures/Diagnostic Modes 01 - 09/Diagnostic Mode 04 - Erase DTC Memory.
3. If the DTC memory was erased, generate readiness code. Refer to => [ Readiness Code ] See: Testing and Inspection/Monitors, Trips, Drive
Cycles and Readiness Codes/Readiness Code.
End of diagnosis.