Passat Sedan L4-2.0L Turbo (BPY) (2007)
Checking internal resistance
-
Using a multimeter, check the Engine Speed (RPM) Sensor (G28) terminals 2 to 3 for resistance.
Specified value: 730 to 1000 ohms (at approx. 20° C)
-
Check Engine Speed (RPM) Sensor (G28) terminals 1 to 2 and 1 to 3 for short circuits.
Specified value: infinite (infinity)
If any of the specified values are not obtained:
-
Replace the Engine Speed (RPM) Sensor (G28).
If the specified values are obtained:
Checking wiring
If the manufacturers test box is being used. Perform the following step.
-
Install the test box.
If the manufacturers test box is not being used. Perform the following step.
-
Remove the Motronic Engine Control Module (ECM) (J623). Refer to => [ Motronic Engine Control Module J623, Replacing ] See: Powertrain
Management/Computers and Control Systems/Engine Control Module/Service and Repair/Removal and Replacement/Motronic Engine Control
Module J623, Replacing.
-
Using a Multimeter, check the Engine Speed (RPM) Sensor (G28) electrical harness connector terminals to the Motronic Engine Control Module