Passat Sedan L4-2.0L Turbo (BPY) (2007)
‹› Torque wrench (V.A.G 1331)
‹› Vehicle Diagnosis, Testing and Information System (VAS 5051)
Removing
-
Disconnect the connector.
-
Remove the bolts.
-
Remove left rear level control system sensor.
Installing
Installation is performed in the reverse order of removal. Observe the following when doing so:
The level control system sensor lever must point toward vehicle exterior.
-
Perform a basic setting on the adaptive chassis DCC. Refer to => [ Adaptive Chassis DCC, Basic Setting ] See: Testing and
Inspection/Programming and Relearning.
-
Perform a basic setting on the headlamps via the Guided Fault Finding function using the (VAS 5051).
Tightening Specifications
Overview
Front Wheel Drive (FWD)
Left Rear Level Control System Sensor Assembly Overview, through MY 2007
‹› Assembly Overview for adaptive chassis DCC, FWD, refer to => [ Left Rear Level Control System Sensor Assembly Overview, FWD ] See: Left
Rear Level Control System Sensor Assembly Overview, FWD
‹› Vehicle level sensor is available as replacement part only complete with coupling rod and upper and lower retaining plates.
‹› Replace with subframe installed.