Passat Sedan L4-2.0L Turbo (BPY) (2007)
-
Release tension from sides - A - and - B - by turning both to the right.
^
Sides - A - and - B - must face in opposite direction. (Shown here with shift lever guide inserted.)
-
Insert shift lever guide with shift lever in the shift housing.
^
The pins - arrow 1 - are still located in shift housing opening.
-
Turn shift lever guide in direction of - arrow 2 - until ball head pin - A - is above shift housing opening.
-
Place selector housing with shift lever guide in larger depression - arrow - on Pressing Support T10083.
^
The shift lever guide must project out of selector housing as far as stop.
-
Insert spring side - A - from above into guide.
-
Pull spring side - B - down and insert it near the guide (in direction of ball head).
Note: The selector bracket is only partially shown to provide a better illustration.