Passat Sedan V6-2.8L (ATQ) (2000)
Oil Pan: Service and Repair
Oil Pan Lower Section, Installing With Solid Gasket
Oil Pan Lower Section, Installing with Solid Gasket
Special Tools and Workshop Equipment Required
-
Torque Wrench -V.A.G 1331-
Procedure
Installation is performed in reverse order of removal, noting the following:
NOTE:
Always Replace Gaskets and Seals.
CAUTION!!
A new molded seal must be installed on engines that were originally equipped with one on the oil pan lower section.
-
Clean the sealing surfaces before installing the oil pan lower section.
-
Set lower part of oil pan in place and fasten all bolts in diagonal sequence to 5 Nm.
-
Fasten bolts for lower part of oil pan in a diagonal sequence.
-
Install stabilizer Refer to:
-
Add engine oil and check oil level.
Tightening Specs:
Tightening Specs