Passat Sedan V6-2.8L (ATQ) (2000)
-
Apply sealant bead -arrow- on clean sealing surface of lower part of oil pan as shown in illustration.
-
Thickness of sealant bead: approximately 1.5 mm.
NOTE:
-
The oil pan (lower part) must be installed within 5 minutes after application of sealant
-
Sealant bead must not be thicker than specified, otherwise sealant could get into oil pan and clog the oil pump strainer.
-
Set lower part of oil pan in place and fasten all bolts in diagonal sequence to 5 Nm.
-
Fasten bolts for lower part of oil pan in a diagonal sequence.
-
Install stabilizer, refer to:
-
Add engine oil and check oil level.
Tightening Torque:
Tightening Torque