Passat Sedan V6-2.8L (ATQ) (2000)
-
In order to prevent damage to heater core, lift heater core only from areas indicated.
Installing
-
Install in reverse order of removal.
-
Always use new coolant after replacement
2. Housing, upper part
3. Evaporator
Evaporator inlet/outlet seal, attaching
-
Evaporator inlet -B- and outlet -A- pipes must be insulated between the halves of the housing with seal -C-.
Evaporator seal, installing
-
Foam seal -B- must must be glued around circumference of evaporator -A-.
-
To allow evaporator water to drain, do not attach foam seal on evaporator in area -C-.
4. Housing, lower part
-
With fresh/recirculating air flap.
-
With central air flap.