Passat Sedan V6-2.8L (ATQ) (2000)
/Page-1529002.png)
11. Valve body
^
Removing; see Fig. 4
^
Installing; see Fig. 9
^
Marking; see Fig. 6
12. Bolt
^
10 Nm (7 ft. lbs.)
13. Conductor strip with connector for solenoid valves
^
With cable transition piece and connector
^
Can be removed and installed with transmission installed
^
Pull off solenoid valves with 3373; see Fig. 3
14. O-ring
^
For cable transition piece
^
Always replace
15. Sealing plug
^
Take out before removing and installing one-way clutch
^
Insert so lug is located in groove on housing; see Fig. 5
^
Place O-rings onto sealing plug
16. O-ring
^
Always replace
17. O-ring
^
Always replace
18. Operating rod for manual selector valve
^
Unhooking; see Fig. 4
^
Install with stepped side facing manual selector valve; see Fig. 7
^
Adjusting; see Fig. 8
Fig. 1 Draining ATF
-
Place pan under transmission oil pan -1-.
-
Remove sealing plug -3-.
-
Remove overflow pipe -2- and allow ATF to drain.
-
Thread overflow pipe in to stop.
Fig. 2 Plug seal, replacing
-
Cut open seal (arrow) with side cutters.
-
Always replace seal
-
After repairs install new seal on plug and screw in hand-tight when filling with ATF
-
Fill with 3 liters (3.17 qt.) ATF then check ATF level and top-up.
