Passat Sedan V6-2771cc 2.8L DOHC (AHA) (1998)
Control Arm Bushing: Service and Repair
Locating Control Arm Bushing, Replacing
Locating control arm bushing, replacing
Special tools required
CAUTION: Always use protective jaw covers when clamping aluminum control arms in a vise.
Pulling bushing out of control arm
Bushing installed position
Note:
^
The arrows on the bushing -1- or groove -2- points toward the joint pin.
^
The maximum permissible deviation is + 5°.
Pulling bushing in
-
Insert bushing in special tool 3347/2.
-
Tighten sleeve 3347/1, spindle 3346/2 and nut together.
-
Pull in bushing -A- onto stop.