Passat Sedan V6-2771cc 2.8L DOHC (AHA) (1998)
Drive Axle With Triple-Rotor Joint
Drive axle with triple-rotor joint, assembly
1. Outer constant velocity (CV) joint
^
Replace complete part only
^
Installing: drive onto shaft with plastic hammer until circlip seats (springs into groove)
^
Greasing.
2. Circlip
^
Always replace
^
Insert in groove in shaft
3. Thrust washer
4. Dished washer
^
Outer diameter (concave side) contacts thrust washer
5. Clamp
^
Always replace
^
Tightening
6. Boot
^
Check for tears and chafing
^
Balance pressure by briefly ventilating boot before tensioning small clamp.
7. Clamp
8. Drive axle
9. Clamp
^
For triple-rotor joint
10. Boot
11. Clamp
^
For triple-rotor joint
12-Cover
^
Destroyed when disassembling.
^
Not required for reassembling; not available as a replacement part.
13. Rectangular sealing ring.
^
Included in repair kit; not used in production
14. O-ring
^
Not required for assembly.
15. Circlip
16. Roller