Passat Sedan V6-2771cc 2.8L DOHC (AHA) (1998)
Shifter M/T: Service and Repair
Disassembling and Assembling
Selector mechanism, disassembling and assembling
1. 5th/Reverse gear detent
^
Removing, installing and checking
2. Torx(R) screw
^
10 Nm (7 ft. lbs.)
3. O-ring
^
Always replace
4. Right stop bolt
^
40 Nm (30 ft. lbs.)
5. Oil seal
6. Relay shaft
7. Oil seal
8. Left stop bolt
^
40 Nm (30 ft. lbs.)
9. Shift detent
10. Torx(R) bolt
^
25 Nm (18 ft. lbs.)
11. Spring pin
12. 5th and reverse gear selector fork
^
Installation position; see Fig. 1
13. 1st gearl2nd gear, 5th and reverse gear shift rod
14. Ball sleeve
^
Removing and installing; see Fig. 2
15. 1st and 2nd gear selector fork
16. Shift yoke
^
Installation position; see Fig. 1
17. Bushing
^
Removing; see Fig. 3
^
Installing; see Fig. 4
18. Ball sleeve
^
Pry off the selector shaft with a screwdriver
^
Press onto the selector shaft