Passat Sedan V6-2792cc 2.8L DOHC (AAA) (1995)
Brake Caliper: Service and Repair
Replacement
Front
Exploded View Of Teves/ATE Front Brake
Component Notes And Information
NOTE:
^
During removal and installation procedures, refer to the component location illustration above and component notes below.
^
Separate connector for brake pad wear indicator.
^
To prevent brake fluid spillage draw the brake fluid from the reservoir using a bleeder bottle that is used ONLY for brake fluid.
WARNING: Brake fluid is poisonous and must NEVER be removed by siphoning with your mouth.
CAUTION: After servicing caliper, depress brake pedal firmly several times to seat the pads in their normal operating position.
1. Screw
2. Brake disc
-
When worn always replace on both sides
-
Remove brake caliper prior to removing
-
Brake disc diameter:288 mm
-
Brake disc thickness: 25 mm
-
Wear limit: G23 mm
3. Brake pads
-
Always replace on both sides
-
Pads are different; pad on piston side has retaining spring and has a specified direction of rotation
-
Pad thickness: 14 mm
-
Wear limit: 7 mm (including backing plate)
4. Retaining spring
-
Insert in both brake caliper housing drillings
5. Brake carrier
-
Supplied as replacement part assembled with sufficient amount of grease on guide pins
-
If protective caps are damaged use repair kit
-
Use grease packet supplied to lubricate guide pins
6. Brake caliper housing
-
Do not disconnect brake hose when changing brake pads