Passat Sedan V6-2792cc 2.8L DOHC (AAA) (1995)
Installation
Installation is the reverse of removal, noting the following information:
^
If the hydraulic system was opened, bleed brake system. See: Brake Bleeding/Service and Repair
^
For vehicles with ABS/EDL, if the brake fluid reservoir has been completely empty (e.g. leaks in brake system) it is necessary to initiate the
"Basic Setting" function of the On Board Diagnostic (OBD) program.
^
Otherwise the standard brake bleeding procedures apply.
Teves Type 04
Control Module, Removing And Installing
Location: Under the rear seat, left.
NOTE: Switch off ignition before disconnecting and connecting connectors.
Removing
-
Fold up rear seat.
-
Press control module securing clips together and pull out.
-
To pull connector off control module, release control module locking bar.
Installation
-
Install in reverse order.
-
Engage connector catch in control module slots (arrow A), press connector on (arrow B) and secure with locking bar (arrow C).