Passat Sedan V6-2792cc 2.8L DOHC (AAA) (1995)
Oil Pump (8)
-
Coat oil pressure pipe at cylinder block and oil pump housing with sealer part No. AMV 188 001 02.
Bolt (9)
-
Tighten to: 25 Nm (18 ft. lbs.).
Bolt (10)
-
Always replace.
-
Install with locking fluid "D6" or equivalent.
Oil Drain Plug (11)
-
Tighten to: 30 Nm (22 ft. lbs.).
Seal (12)
-
Always replace.
Oil Spray Jet (13)
-
For piston cooling.
-
Opening pressure: 2.0 bar (29 psi).
Oil Pan Bolt (14)
-
Tighten to: 15 Nm (11 ft. lbs.).
Oil Pan Gasket (15)
-
Replace if damaged.
-
Before fitting gasket, coat pan flange and cylinder block with "D2", or equivalent.
Oil Pan (16)
-
Clean sealing surfaces before installing.
Oil Cooler (17)
-
Coat contact area to flange outside the seal with sealer AMV 188 100 02, or equivalent.
-
Ensure clearence between adjacent components.
Oil Cooler Cover (18)
-
Tighten to: 25 Nm (18 ft. lbs.).
Oil Filter Housing Gasket (19)
-
Always replace.
-
Note installation position.
-
Oil before installing.
Dipstick (21)
-
The oil level must not be above the max. mark on the dipstick.
Guide Tube 22)
-
Secure with bolt to intake manifold lower section.
Oil Check Valve (23)
-
Tighten to: 5 Nm (44 inch lbs.).
-
Note installed position.
-
Clean as required.
REMOVAL
NOTE: Oil spray jets are installed in main bearings web 2 and 7.
-
Remove crankshaft.