Passat Sedan V6-2792cc 2.8L DOHC (AAA) (1995)
-
Tighten to: 100 Nm (74 ft. lbs.).
-
To remove and install counter-hold with 24 mm open jaw wrench on camshaft.
-
Oil the bolt head contact surface when installing.
Pivot Pin (4)
-
Tighten to: 25 Nm (18 ft. lbs.)..
Seal (5)
-
Always replace.
Chain Tensioner For Double Chain (6)
-
Bleed before installing as follows:
-
Push a piece of wire (0 0.8 mm) through the hole of the pressure piston (arrow) up to ball valve and press pressure piston and housing together
onto stop.
NOTE: If the pressure piston moves out again, repeat bleeding procedure.
-
Only rotate engine with tensioner installed.
Sprocket For Single Chain (8)
-
Refer to timing chain adjustment found under Timing Components.
Double Chain (9)
-
Mark single and double chains before removing them (paint or mark an arrow pointing in direction of normal engine rotation).
NOTE: Do not mark the chain using a center punch or with any method that scratches or deforms the metal surfaces.
-
Refer to timing chain adjustment found under Timing Components.
Intermediate Shaft Sprocket Bolt (10)
-
Tighten to: 100 Nm (74 ft. lbs.).
Sprocket For Double Chain (11)
-
Refer to timing chain adjustment found under Timing Components.
Tensioner Rail Bolt (12)
-
Tighten to: 10 Nm (7 ft. lbs.).