Passat Sedan V6-2792cc 2.8L DOHC (AAA) (1995)
11
Valve body
-
Removing, refer to Fig. 4, below.
-
Installing, refer to Fig. 9, below.
-
Marking, refer to Fig. 6, below.
-
Installing seal-item 10-
12
Bolt
-
Tighten to: 10 Nm (7 ft lb)
13
O-ring
-
For wiring transition piece
-
Always replace
14
Conductor strip With wiring transition piece and connector
-
Can be removed and installed with transmission installed
-
Remove solenoid valves with 3373, refer to Fig. 3, below.
15
Clip
16
Wiring connector
-
Attach to transmission housing
17
Clip Insert lug of wiring connector in recess of clip
18
Nut
-
Tighten to: 10 Nm (7 ft lb)
19
Plug for solenoid valves
-
Remove solenoid valves with 3373, refer to Fig. 3
20
Sealing plug
-
Take out before removing and installing free wheel
-
Install so that lug is located in groove on housing, refer to Fig. 5, below.
-
Place O-rings onto sealing plug
21
O-ring
-
Always replace
22
O-ring
-
Always replace
23
Operating rod for manual selector valve
-
Unhooking, refer to Fig. 4, below.
-
Install with stepped side facing manual selector valve, refer to Fig. 7, below.
-
Adjusting, refer to Fig. 8, below.
PROCEDURES
Fig. 1 ATF, draining
-
Place container under transmission.
-
Remove plug -2-.
-
Remove overflow tube -1- and allow ATF to drain.
-
Thread overflow tube in to stop.
Fig. 2 Plug seal, replacing
-
Cut open seal -arrow- with side cutters.
-
After repairs install new seal to plug and thread in hand tight to fill with ATF.
-
Pour in 3 liters of ATF then check ATF level and top-up, refer to Topping Up Transmission Oil.