Passat Sedan V6-2792cc 2.8L DOHC (AAA) (1995)
5
- Inner plate
- Quantity
- Installing
6
- Outer plate
- Quantity
- Installing
- Always 1.5 mm thick
7
- Outer plate
- Always 2 mm thick
- Installing
8
- Corrugated washer
9
- Circlip
- Removing and installing
10 - Piston cap
- Sealing lips are vulcanized to cap
- Moisten sealing lips with ATF before installing
- Turn cap slightly while installing
11 - Intermediate spring ring
- With spring supporting shell and compression springs
12 - Piston
- Sealing lips are vulcanized to piston
- Moisten sealing lips with ATF before installing
- Turn piston slightly while installing
13 - Piston ring (small diameter)
- Installation position
- Installing
14 - Piston ring
- Installation position
- Installing
15 - Clutch housing with turbine shaft
- Check bearing bushings. Replace housing if bushings are damaged.
- Before inserting inner plate carrier corrugated washer -8-, insert inner and outer plates in clutch
16 - Piston ring
- Installation position
- Installing
Removing and installing circlip
- Press piston cap with intermediate spring ring down far enough for circlip (-arrow-) to be inserted in groove.