Passat Sedan V6-2792cc 2.8L DOHC (AAA) (1995)
13
Pedal cluster mounting bracket
-
Always replace self-locking nuts for mounting bracket and brake master cylinder
-
Tighten to: 25 Nm (18 ft lbs)
14
Brake pedal
PROCEDURES
REMOVAL
-
Remove over-center spring, refer to Replacement. See:
-
Separate clutch pedal from master cylinder and push operating rod toward engine compartment onto stop., refer to Replacement. See: Clutch
Hydraulic System/Clutch Slave Cylinder/Service and Repair
-
Remove clutch pedal securing clip from pivot pin, by prying tab up with a screwdriver and pushing clip off.
-
Drive pivot pin out with drift.
-
Remove clutch pedal.
INSTALLATION
-
Install in reverse order of removal