Passat Sedan V6-2792cc 2.8L DOHC (AAA) (1995)
7
Clamp
-
Always replace
-
Tensioning, refer to Fig. 7 and Fig. 8
8
Boot for 90 mm diameter constant velocity joint
-
Polyester elastomer version
-
Check for tears and chafing
-
The balance pressure briefly ventilate boot before tensioning the small clamp, refer to Fig. 7
-
Installation position for left shaft, wheel end, refer to Fig. 10 and Fig. 11
-
Installation position for right shaft, wheel end, refer to Fig. l2
9
Clamp
-
Always replace
-
Tensioning, refer to Fig. 7 and Fig. 8
10
Dished washer
-
Outer diameter (concave side) contacts thrust washer
11
Thrust washer
12
Circlip
-
Always replace
-
Insert in shaft groove
13
Outer constant velocity joint, 90 mm diameter
-
Only replace complete
-
Removing, refer to Fig. 2
-
Installing: drive onto shaft with plastic hammer until compressed circlip seats
-
Greasing, refer to Notes above
-
Checking. See: Constant Velocity Joint/Testing and Inspection
14
Outer constant velocity joint, 90 mm diameter
-
For vehicles with 16V and VR6
-
Wedge splines, larger diameter
-
Only replace complete
-
Removing, refer to Fig. 2
-
Installing: drive onto shaft with plastic hammer until compressed circlip seats
-
Greasing, refer to Notes above
-
Checking. See: Constant Velocity Joint/Testing and Inspection
15
Vibration damper
-
Removing installing, refer to Fig. 1
-
Installation position, refer to Fig. 1
-
Available as spare part
-
Is only installed on the right drive shaft tube.
16
Clamp
-
Always replace
17
Support rings
-
On rubber type boot only
-
On transmission end only Parts microfiche
18
Boot for 100 mm diameter constant velocity joint
-
Polyester elastomer version
-
Check for tears and chafing
-
To balance pressure briefly ventilate boot before tensioning the small clamp, refer to Fig. 7
19
Protective cap
20
Hex bolt
-
Tighten to: 35 Nm (26 ft. lbs.)
NOTE: For these procedures, use the tools shown in the following illustrations or their equivalents.