Passat Sedan V6-2792cc 2.8L DOHC (AAA) SFI (1997)
Control Arm: Diagrams
1
Hex Bolt
-
Tighten to: 35 Nm (26 ft. lbs.)
2
Ball Joint
-
Checking. See: Ball Joint/Testing and Inspection
-
Check rubber boot for damage and if necessary, replace ball joint
-
Removing and installing. See: Ball Joint/Service and Repair
-
Mark installation position.
-
If replaced set to center of elongated hole and check alignment
3
Self-Locking Hex Nut
-
Tighten to: 45 Nm (33 ft. lbs.)
4
Captive Locknuts
5
Control Arm Rear Mounting
6
Control Arm
-
Elongated holes are not for camber adjustment!
7
Air Guide Plate
-
Secured to control arm by clip
8
Control Arm Front Mounting
9
Hex Bolt
-
12 x 1.5 x 78 mm
-
Tighten to: 70 Nm (52 ft. lbs.) and turn 90° further
10
Hex Bolt
-
12 x 1.5 x 65 mm
-
Tighten to: 70 Nm (52 ft. lbs.) and turn 90° further
11
Connecting Link
-
With rubber mounting
12
Mounting Link
-
Conical control arm