Passat Sedan V6-2792cc 2.8L DOHC (AAA) SFI (1997)
Case: Service and Repair
Disassembly/Assembly
1
-
Cone-head bolt
-
Installed in transmissions with springs behind axle flange shafts
2
-
Axle flange shaft with spring
-
Removing and installing -- Ref Differential Side Seal, Manual Transmission See: Seals and Gaskets/Service and Repair
3
-
Axle flange shaft without spring
Removing Axle Flange Shaft Without Spring
-
Place chisel or spacer (A) under axle flange and pull flange from differential gears by turning bolt (B) (B = previously removed
housing bolt)
NOTE: If the axle flange shaft fails to come out straight, use two spacers (A), and bolts (B), positioned opposite each other. Tighten both
bolts alternately and evenly