Passat Sedan V6-2792cc 2.8L DOHC (AAA) SFI (1997)
Installing Axle Flange Shaft Without Spring
-
Clamp axle flange shaft in vise (fitted with protective jaws)
-
Press old circlip out of flange shaft groove by installing new circlip (A)
-
Drive in axle flanges shafts with drift (e.g. VW 295)
4
-
Circlip (always replace)
5
-
Torx(r) socket-head bolt (self-locking always replace)
-
For reverse idler shaft
-
Tightening torque: 30 Nm (22 ft lb)
6
-
0-rings (always replace)
7
-
Bolt
-
Tightening torque: 25 Nm (18 ft lb)
8
-
Pivot pin
9
-
Bolt
-
Tightening torque: 25 Nm (18 ft lb)
10 -
Cover plate
11 -
Transmission housing
12 -
Clutch housing
13 -
Hex bolt
-
Tightening torque: 25 Nm (18 ft lb) plus additional 1/4-turn (90°)
14 -
Selector shaft mechanism
15 -
Hex bolt
-
Tightening torque: 25 Nm (18 ft lb)