Passat Sedan V6-2792cc 2.8L DOHC (AAA) SFI (1997)
alternately and evenly.
-
Withdraw axle flange oil seal using VW 681 extractor lever
-
Remove axle flange (either side)
Installation
-
Clamp axle flange shaft in vise (fitted with protective jaws)
-
Press old circlip out of flange shaft groove by installing new circlip (A)
CAUTION: Always replace axle flange circlip.
-
Drive in new axle flange oil seal until flush
-
Fill space between sealing lip and dust seal with multi-purpose grease
-
Drive in axle flange using 30-505 mandrel
-
Check transmission oil, if necessary top off to lower edge of filler opening
Transmissions With Springs Behind Axle Flanges
Identification of Seal