Passat Sedan V6-3.6L (BLV) (2008)
/Page-2202001.png)
Front Door Window Motor: Service and Repair
Front Door Window
Window Regulator Motor
Removing
-
Remove front door trim.
-
Fix window using adhesive tape so that it does not slip down.
-
Disconnect all harness connectors - 3 -.
-
Remove the three bolts - 2 -.
-
Remove window regulator motor with control module - 1 - from subframe.
Installation
CAUTION!
It is necessary to code the additional functions and pinch protection each time a new window regulator motor (door control module) is
installed.
-
Place window regulator motor on and pull door window lightly up and down so that splines are located better between motor and cable drum.
Tightening specification for window regulator motor screws - 2 -: 3.5 Nm
-
Code the new window regulator motor using the (VAS 5051 A).
