Passat Sedan V6-3.6L (BLV) (2008)
Rear Door Latch: Service and Repair
Lock Cylinder Housing
Door Components
Lock Cylinder Housing
‹› Removing and installing the lock cylinder housing is described. Removing and installing the left lock cylinder is identical.
Removing
‹› Cover cap for lock cylinder housing has been removed. Refer to => [ Lock Cylinder Housing Cover Cap ] See: Front Door/Service and
Repair/Front Door/Door Components
-
Pry out cover cap - 4 - in front of bolt - 3 -.
-
Pull out door handle - 1 - in - direction of arrow - until it stops and unscrew bolt - 3 - far enough until lock cylinder housing - 2 - can be pulled
out.
-
Remove lock cylinder housing - 2 - at right angle to door from door handle mounting bracket.
‹› Door handle remains standing in pulled-out position. Do not attempt to press door handle in, otherwise retaining tab on mounting bracket breaks
off and a removed door handle can no longer be installed.
Installation
In pulled-out position - arrow -, door handle must stand off from door.
-
Insert lock cylinder housing - 3 - at right angle into mounting bracket.