Passat Sedan V6-3.6L (BLV) (2008)
Rear Door Panel: Service and Repair
Door Trim
Rear Door Trim
‹› Removal and installation is described for the right rear door trim panel. Removal and installation of the left rear door trim panel is performed in
the same manner.
Removal
-
Switch off ignition.
Vehicles with manual window regulators
-
Remove window crank. Refer to => [ Window Crank ] See: Front Door/Front Door Panel/Service and Repair/Window Crank
All vehicles
-
Pry the upper section of the grip shell - 1 - out of the pull handle in the door trim using the (3409).
-
Remove bolts - 2 - and - 3 - (4.5 Nm).
-
Remove bolt - 4 - (2 Nm).
-
Disengage door trim from mounts in lower area using (3392).
-
Disengage door trim from mounts on the sides using (3392).
-
Pull door trim vertically upward out of window shaft.
-
Depending on vehicle equipment, disconnect wiring harnesses from door trim.
-
Disengage the cable - 5 - from the interior door mechanism - 6 -.