Passat Sedan V6-3.6L (BLV) (2008)
Trunk / Liftgate Hinge: Service and Repair
Rear Lid
Rear Lid
Rear Lid Hinge
‹› Removal and installation is described for left hinge. The same instructions apply for removal and installation for the right hinge.
Removing
-
Remove rear shelf.
-
Remove the left luggage compartment trim panel
-
Remove the rear lid.
-
Remove the gas-filled strut - 7 - from hinge - 1 -. Refer to => [ Gas Strut ]. See: Service and Repair/Rear Lid/Gas Strut
-
Remove the seal around the hinge. Refer to => [ Hinge Gasket Assembly Overview ] See: Service and Repair/Rear Lid Overview
-
Disconnect harness connectors - 6 - and guide electrical wires out of hinge - 1 -.
-
Remove the screws - 3 - and remove the hinge - 1 - through the openings in the rear shelf - 4 - and the sealing channel- 5 -.
Installation