Passat Sedan V6-3.6L (BLV) (2008)
‹› To left rear brake caliper
‹› Identification: diameter 5.25 mm and tube fitting with shorter thread M12 x 1
‹› Marked on hydraulic unit with HL
5
Brake Line
‹› To right rear brake caliper
‹› Identification: diameter 5.25 mm and tube fitting with thread M 10 x 1
‹› Marked on hydraulic unit with HR
6
Brake Line
‹› To left front brake caliper
‹› Identification: diameter 5.25 mm and tube fitting with shorter thread M12 x 1
‹› Marked on hydraulic unit with VL
7
Brake Line
‹› Master brake cylinder/primary piston circuit to hydraulic control unit
‹› Identification: diameter 8.5 mm or diameter 6 mm and tube fitting with longer thread M12 x 1
‹› Marked on hydraulic unit with HZ1
8
Brake Line
‹› Master brake cylinder/secondary piston circuit to hydraulic unit
‹› Identification: diameter 8.5 mm or diameter 6 mm and tube fitting with longer thread M12 x 1
‹› Marked on hydraulic unit with HZ2
9
Heat Shield
10
Inner TORX(R) Bolt
‹› 12 Nm
11
Brake Booster
‹› On vehicles with a hydraulic brake booster, a vacuum sensor is installed, refer to => [ Brake Booster Vacuum Sensor ] See: Power Brake
Assist/Brake Booster Vacuum Sensor/Service and Repair/Brake Booster Vacuum Sensor
‹› Removing and installing, refer to => [ Brake Booster ] See: Power Brake Assist/Vacuum Brake Booster/Service and Repair/Brake Booster
12
Bracket
13
Hex Nut
‹› 20 Nm
14
Rubber Insulation
15
Inner TORX(R) Bolt
‹› 10 Nm
16
Bracket