Passat Sedan V6-3.6L (BLV) (2008)
‹› To remove, first remove brake caliper and carrier
4
TORX(R) Bolt
‹› 4 Nm
5
Brake Carrier
‹› Bolt to wheel bearing housing
6
Retaining Spring
‹› Insert in both holes of brake caliper
7
Ribbed Bolt
‹› 200 Nm
‹› Clean if using again.
8
Brake Pads
‹› Thickness 14 mm without backing plate
‹› With wear indicator (left front)
‹› When wear limit is reached (limit: approximately 4 mm without backing plate), the warning lamp in the instrument cluster comes on
‹› Wear limit: 2 mm without backing plate
‹› Check the thickness.
‹› Must always be replaced together on both sides of axle
‹› Removing and installing, refer to => [ Brake Pads ] See: Front Brakes, FN 3 Brake Caliper
9
Brake Caliper
‹› Do not unscrew brake hose when replacing brake pad
‹› Removing and installing, refer to => [ Brake Caliper ] See: Front Brakes, FN 3 Brake Caliper
‹› Assembly overview, refer to => [ Front Brake Assembly Overview, FN 3 Brake Caliper ] See: Front Brake Assembly Overview, FN 3 Brake
Caliper
10
Guide Pins
‹› 30 Nm
11
Cap
‹› Remove
12
Brake Hose with Banjo Fitting and Union Bolt
‹› 35 Nm
13
Bolt
‹› 8 Nm
14
Bracket
15
Retaining Clip