Passat Sedan V6-3.6L (BLV) (2008)
2
Hex Bolt, Self-Locking
‹› Replace
‹› 35 Nm
‹› When loosening and tightening, counter-hold at guide pin
3
Dust Cap
4
Bleeder Valve
‹› 10 Nm
‹› Apply a thin coat of assembly paste G 052 150 A2 to the threads before screwing in.
5
Inner TORX(R) Bolt
‹› 12 Nm
6
Parking Brake Motor
7
Seal
8
Guide Pins
‹› Grease before pulling on protective cap
9
Protective Cap
‹› Pull onto brake carrier and guide pin
10
Brake Carrier with Guide Pins and Protective Cap
‹› Supplied as an assembled replacement part with sufficient grease on guide pins
‹› If protective caps or guide pins are damaged, install repair kit. Use supplied grease packet to lubricate guide pins.
11
Protective Cap
‹› Pull onto piston with outer sealing lip
‹› Removing and installing, refer to => [ Piston, Rear Brake Caliper ] See: Overhaul/Piston, Rear Brake Caliper
12
Pistons
‹› Removing and installing, refer to => [ Piston, Rear Brake Caliper ] See: Overhaul/Piston, Rear Brake Caliper
‹› Apply thin coat of assembly paste G 052 150 A2 to piston before inserting
13
Seal
‹› Removing and installing, refer to => [ Piston, Rear Brake Caliper ] See: Overhaul/Piston, Rear Brake Caliper
14
Pressure Nut
Rear Brakes, CII 38 and C II 41 Brake Calipers
Rear Brakes, CII 38 and C II 41 Brake Calipers
=> [ Brake Pads ]
=> [ Brake Caliper ]