Passat Sedan V6-3.6L (BLV) (2008)
‹› Brake line must contact stop when hex socket heat screws are tightened, otherwise flared head will not be formed correctly.
-
Clamp brake line in flaring tool until it cannot be moved any more. Fold stop - A - up and tighten hex socket head screws diagonally with angle
screw driver - C -.
-
Turn spindle to stop in flaring tool.
-
Turn spindle back.
-
Loosen hex socket head screws diagonally.
-
Remove brake line from flaring tool, clean and check brake line and flared head.
Briefly rinse part of brake line remaining in vehicle.
-
Connect the (VAS 5234), place the bleeder container hose on the flared head of the brake line and run the (VAS 5234) briefly until some brake
fluid runs through.
-
Clean the brake line with compressed air.
-
Join brake lines with connecting piece - E -.