Passat Sedan V6-3.6L (BLV) (2008)
/Page-1277003.png)
CAUTION!
Do not remove the gasket when assembling the parking brake motor.
-
Carefully set the parking brake motor in place, paying attention to the seat of the seal.
-
Rotate the parking brake motor until the bolt hole and threads are aligned.
Make sure that the parking brake motor is seated flush against the brake caliper. Do not, under any circumstances, pull the parking brake motor against
the brake caliper using the bolts.
-
Set the TORX(R) bolts - arrows - in place by hand and then tighten.
-
Install connector.
-
Perform basic setting of brake system.
-
(VAS 5051), connecting and selecting functions. Refer to => [ VAS 5051, Connecting and Selecting Functions ] See: Antilock Brakes / Traction
Control Systems/Testing and Inspection/Scan Tool Testing and Procedures.
