Passat Sedan V6-3.6L (BLV) (2008)
Parking Brake Release Motor: Service and Repair
Parking brake motor, removing and installing
Special tools, testers and auxiliary items required
^
Torque wrench V.A.G 1331
^
Vehicle diagnostic, test and information system VAS 5051
^
Diagnostic cable VAS 5051/1 or VAS 5051/3
Removing
Note:
^
Ignition must be switched off for at least 30 seconds before disconnecting the connector.
-
Pull connector - 1 - off from parking brake motor.
-
Remove both Torx bolts - arrows - from parking brake motor.
-
Pull off parking brake motor from brake caliper.
-
Remove seal.
Make sure that the ring groove of the seal and contact surface of the parking brake motor do not become damaged.