Passat Sedan V6-3.6L (BLV) (2008)
/Page-1285002.png)
-
Clean ring groove and contact surface of parking brake motor.
Installing
-
Lightly coat new sealing ring with brake fluid and then install it.
-
Turn spindle back slightly with help of a Torx insert T45 - A -, until parking brake motor can be correctly positioned.
CAUTION: The sealing ring must not unscrew when installing the parking brake motor.
-
Carefully set parking brake motor in place, paying attention to the seat of the seal.
-
Rotate parking brake motor so far until the bolt hole and threads are aligned.
Make sure that the parking brake motor is seated flush against the brake caliper. Do not, under any circumstances, pull parking brake motor against the
brake caliper using the bolts.
-
Set Torx bolts - arrows - in place by hand and then tighten.
-
Install connector.
-
Perform basic setting of brake system.
