Passat Sedan V6-3.6L (BLV) (2008)
Camshaft: Service and Repair
Camshafts
Special tools, testers and auxiliary items required
‹› Camshaft Bar (T10068 A)
‹› Counter-Holder Tool (T10069)
‹› Torque Wrench (5-50 Nm) (V.A.G 1331)
‹› Torque Wrench (40-200 Nm) (V.A.G 1332)
‹› Adjustment Tool (T10332) (Without a mechanical vacuum pump)
‹› Adjustment Tool (T10363) (With a mechanical vacuum pump)
‹› Sealant (D 176 501 A1)
Removing
CAUTION!
When doing any repair work, especially in the engine compartment, pay attention to the following due to clearance issues:
‹› Route all lines and wires in their original locations.
‹› Make sure the wires have enough clearance to all moving or hot components.
-
Remove the air filter housing. Refer to => [ Air Filter Housing Overview ] See: Intake Manifold/Service and Repair/One Piece Intake Manifold.
-
Bring the lock carrier into the service position. See: Body and Frame/Lock Carrier
-
Remove the intake manifold. Refer to => [ Intake Manifold ] See: Intake Manifold/Service and Repair/One Piece Intake Manifold.
-
Remove the cylinder head cover. Refer to => [ Cylinder Head Cover ] See: Cylinder Head Assembly/Valve Cover/Service and Repair.
‹› Mark the connector to the component before disconnecting the connectors.
-
Disconnect the following connectors.
1 - Camshaft Position (CMP) Sensor (G40)
2 - Camshaft Adjustment Valve 1 (N205)
3 - CMP Sensor 2 (G163)