Passat Sedan V6-3.6L (BLV) (2008)
-
Install bearing caps 3 and 11 and tighten to 5 Nm + 45° (1/8) additional turn.
B - Exhaust Camshaft
-
Tighten bearing caps 6 and 10 alternately and in a diagonal sequence to 5 Nm + 45° (1/8) additional turn.
-
Install bearing caps 2 and 14 and tighten to 5 Nm + 45° (1/8) additional turn.
-
Install bearing caps 8 and 13 and tighten to 5 Nm + 45° (1/8) additional turn.
-
Install bearing caps 4 and 12 and tighten to 5 Nm + 45° (1/8) additional turn.
Continuation for Both Camshafts
-
Install the (T10068 A) into both camshaft grooves.
-
Before installing, check the control housing strainer for contamination, refer to => [ Checking Control Housing
Strainer for Contaminants ] See: Variable Valve Timing Cover / Housing/Service and Repair.
-
Before installing the control housing, lubricate the seals for the camshafts.
-
Lubricate the contact surface on the seals inside the control housing. Slowly slide the control housing over the camshaft seals.
-
Install the control housing and apply locking adhesive (D 000 600 A2) to the bolts - arrows -. Tighten the bolts to 8 Nm.