volkswagen Workshop Repair Guides

Volkswagen Workshop Service and Repair Manuals

ABOUT US
Camshaft Adjuster With Timing Chain, Installing|Page 1881 > < Camshaft Adjuster With Timing Chain, Installing|Page 1879

Passat Sedan V6-3.6L (BLV) (2008)

Page 11
background image

If the mark match:

-

Secure the respective camshaft to be tightened using a 27 mm open end wrench on the recess - arrow -.

‹› The (T10068 A) must not be installed during this process.

‹› Be aware that all sprocket bolts must be replaced.

-

Tighten the new bolts for the intake and exhaust camshaft adjuster to 60 Nm + 90° (1/4) additional turn.

Install the sealing flange. Refer to => [ Sealing Flange, Transmission Side ] See: Cylinder Block Assembly/Crankshaft Seal Retainer/Service and
Repair.

Camshaft Adjuster With Timing Chain, Installing|Page 1881 > < Camshaft Adjuster With Timing Chain, Installing|Page 1879