Passat Sedan V6-3.6L (BLV) (2008)
Crankshaft: Service and Repair
Crankshaft Sensor Wheel
Sensor Wheel on Crankshaft
Special tools, testers and auxiliary items required
^
Torque wrench V.A.G 1331
^
Locking fluid D 154 100 A1
Procedure
Make sure the crankshaft/sensor wheel contact surface is free of oil and grease.
Note:
^
Sensor wheel may only be installed once, since attachment points - arrows - of countersunk screws - 1 - in sensor wheel - 2 - are so severely
deformed after mounting the second time that bolt heads make contact on the crankshaft - 3 - and sensor wheel lies loosely under the bolt heads.
-
Apply a thin coat of locking compound D 154 100 A1 to contact surfaces of crankshaft and sensor wheel for additional security.
-
When installing, make sure that marking -VR6- - arrow - stands at individual threaded hole.
-
Tighten all new screws lightly by hand.
-
Then tighten new screw - 1 - to 10 Nm + 90 degree (1/4 rotation).
-
Then new screws - 2 - to 10 Nm + 90 degree (1/4 rotation).