Passat Sedan V6-3.6L (BLV) (2008)
-
Disengage socket - 1 - and pull it off handle part - 2 -.
-
Turn around handle part - 2 - of torque wrench 180° and insert socket again.
-
Set turning direction of torque wrench to left at socket.
-
Insert a multi-point socket insert M10 - 1 - in generator shaft.
-
Counter hold (VAS 3400) using 17 mm open end wrench.
-
Tighten ribbed belt pulley with freewheel by turning generator driveshaft toward left using (V.A.G 1332).
-
Tighten all threaded connections to the specification shown in => [ Fastener Tightening Specifications, Generator, All Vehicles ] See:
Specifications/Mechanical Specifications/Starting and Charging/Alternator/Fastener Tightening Specifications, Generator, All Vehicles.