Passat Sedan V6-3.6L (BLV) (2008)
Drive Belt: Service and Repair
Ribbed Belt Pulley With Freewheel, Valeo
Ribbed Belt Pulley With Freewheel, Valeo
Special tools, testers and auxiliary items required
‹› Multi-point adapter (VAS 3400)
‹› Torque Wrench (V.A.G 1332)
‹› TORX screwdriver insert (V.A.G 1603/1)
Removing:
-
Remove generator, refer to => [ Generator ] See: Starting and Charging/Charging System/Alternator/Service and Repair/Removal and
Replacement/Generator (2.0L) or => [ Generator ] See: Starting and Charging/Charging System/Alternator/Service and Repair/Removal and
Replacement/Generator (3.6L).
-
Tighten the generator in a vise at the mounting points.
-
Remove protective cap from ribbed belt pulley with freewheel.
-
Insert (VAS 3400) into ribbed belt pulley with freewheel of generator using open end wrench 17 mm.
-
Insert (V.A.G 1603/1) into generator shaft.
-
Loosen the threaded connection by rotating clockwise, while counter holding with the box-end wrench.
-
Hold ribbed belt pulley with freewheel in place by hand and turn at generator driveshaft until ribbed belt pulley with freewheel can be removed.
Installing:
Install in reverse order of removal, noting the following:
-
Next, screw ribbed belt pulley with freewheel onto generator driveshaft by hand until it reaches stop.