Passat Sedan V6-3.6L (BLV) (2008)
Oil Filter Housing: Locations
Oil Filter Housing Assembly Overview
1. Seal
^
Replace
^
Oil before assembling
2. Oil pressure switch F1 20 Nm
^
0.9 bar switch
^
If sealing ring is leaking cut open and replace.
3. Oil cooler sealing ring
^
Replace
^
Note installation position
^
Oil before assembling
^
Insert into grooves on oil cooler
4. Oil cooler
^
Ensure sufficient clearance to surrounding components
^
If large quantities of metal particles or abraded material are detected during engine repairs, it may be an indication for a damaged crankshaft or
rod bearings. To prevent further damage, perform the following steps after the repair:
5. Seal
^
Replace
^
Oil before assembling
6. Oil cooler cover, 25 Nm
7. Coolant hoses
^
Ensure seated tightly
8. Locking bolt, 15 Nm
^
If sealing ring is leaking cut open and replace.
9. 23 Nm
10. Oil drain plug, 10 Nm
11. O-ring
^
Replace
^
Oil before assembling
12. Screw cap, 25 Nm
13. Oil filter element
^
Observe change intervals
^
If large quantities of metal particles or abraded material are detected during engine repairs, it may be an indication for a damaged crankshaft or
rod bearings. To prevent further damage, perform the following steps after the repair:
14. Oil filter housing