Passat Sedan V6-3.6L (BLV) (2008)
-
Insert the camshaft bar T10068 A into both shaft grooves.
-
Now guide drive chain for camshafts and high pressure pump through opening in cylinder head or cylinder head gasket from above.
-
Insert small drive pinion with installed chain into recess - arrow - and bolt it on hand tight.
-
Lock vibration damper using counter-holder tool T10069.
-
With a new bolt, tighten both chain sprockets on oil pump shaft to 60 Nm, then turn an additional 1/4 (90 degree). (90 degree) further only use
bolts with strength category 10.9
Note:
^
Be aware that all chain sprocket bolts must be replaced.
-
Insert guide rail - 2 - through opening in cylinder head and secure it tightly with mounting bolts - 1 - and - 3 -.