Passat Sedan V6-3.6L (BLV) (2008)
6
Seal
‹› Replace
7
Vacuum Actuator
‹› For the intake manifold flaps.
‹› Pay attention to the position of the intake manifold flaps when installing: the flaps must be open.
‹› Checking the vacuum actuator for the intake manifold flaps. Refer to => [ Intake Manifold Flap Vacuum Actuator, Checking ] See: Testing
and Inspection/One Piece Intake Manifold.
8
Intake Manifold
‹› Removing and installing, refer to => [ Intake Manifold ] See: .
‹› With vacuum reservoir installed. For information on checking, refer to => [ Vacuum Reservoir in Intake Manifold, Checking for Leaks ] See:
Testing and Inspection/One Piece Intake Manifold.
‹› With intake manifold flaps.
9
from Evaporative Emission (EVAP) Canister Purge Regulator Valve (N80)
10
from Leak Detection Pump (LDP) (V144)
11
Bolt
‹› 20 Nm
12
to Suction Jet Pump
‹› Suction Jet Pump Overview, refer to => [ Suction Jet Pump Overview ]. See: Overview/Suction Jet Pump Overview
13
Grommet
‹› Replace if damaged.
14
Vacuum Hose
‹› To the IMRC valve.
15
Intake Manifold Support
16
Throttle Valve Control Module (J338)
‹› With the throttle drive (for Electronic Power Control (EPC)) (G186), throttle drive angle sensor 1 (for EPC) (G187) and throttle drive angle
sensor 2 (for EPC) (G188).
‹› When replacing, adapt the Engine Control Module (ECM) to the throttle valve control module, refer to "Guided Functions" in the vehicle
diagnostic tester.
17
Bolt
‹› 7 Nm
18
Gasket
‹› Replace
‹› Ensure the gasket is correctly seated in the intake manifold.
19
Connection
‹› For the crankcase ventilation