Passat Sedan V6-3.6L (BLV) (2008)
/Page-637003.png)
‹› With the Positive Crankcase Ventilation (PCV) heating element (N79).
‹› From the cylinder head cover.
20
Fuel Rail
‹› For cylinders 2, 4 and 6.
‹› Fuel injector springs - item 3 - must be replaced before installing.
‹› Tighten uniformly, starting from the inside and working toward the outside
‹› Fuel rail, injectors and high pressure pump overview, through 07.07. Refer to => [ Fuel Rail, Injectors and High Pressure Pump Overview,
through 07.07 ].
‹› Fuel rail, injectors and high pressure pump overview, from 08.07. Refer to => [ Fuel Rail, Injectors and High Pressure Pump Overview, from
08.07 ]. See: Overview/Fuel Rail, Injectors and High Pressure Pump Overview, From 08.07
21
Bolt
‹› 30 Nm + 90° (1/4) additional turn.
‹› Replace
‹› Tighten the fuel rail uniformly, starting from the inside and working toward the outside.
Fuel Rail, Injectors and High Pressure Pump Overview, From 08.07
One Piece Intake Manifold
Fuel Rail, Injectors and High Pressure Pump Overview, from 08.07
‹› Do not disassemble the high pressure pump!
‹› If a fuel injector is removed, the combustion chamber Teflon seal and O-ring must be replaced. Refer to => [ Fuel Injectors ] See: .
‹› Read the safety precautions before beginning work. Refer to => [ Safety Precautions ] See: Powertrain Management/Fuel Delivery and Air
Induction/Service Precautions/Safety Precautions/Fuel Supply.
‹› Observe the rules for cleanliness. Refer to => [ Clean Working Conditions ] See: Powertrain Management/Fuel Delivery and Air Induction/Service
Precautions/Clean Working Conditions/Multiport Fuel Injection.
CAUTION!
Read the safety precautions before beginning work. Refer to => [ Safety Precautions ] See: Powertrain Management/Fuel Delivery and
Air Induction/Service Precautions/Safety Precautions/Fuel Supply.
The fuel pressure in the high pressure pipe can be up to 120 bar! Wear protective goggles and protective clothing to prevent injuries and
contact with skin. Before disconnecting the fuel pipe, place a cloth around the connection point. Then release pressure by carefully
loosening the union nuts.
