Passat Sedan V6-3.6L (BLV) (2008)
5
Bolt
‹› 10 Nm
6
from Evaporative Emission (EVAP) Canister Purge Regulator Valve (N80)
7
Bolt
‹› 20 Nm
8
Rear Intake Manifold Support
9
Seal
‹› Replace
10
Bolt
‹› 7 Nm
11
Throttle Valve Control Module (J338)
‹› With the throttle drive (for Electronic Power Control (EPC)) (G186), throttle drive angle sensor 1 (for EPC) (G187) and throttle drive angle
sensor 2 (for EPC) (G188).
‹› When replacing, adapt the Engine Control Module (ECM) to the throttle valve control module, refer to "Guided Functions" in the vehicle
diagnostic tester.
12
Bolt
‹› 3.5 Nm
13
Connection
‹› For the crankcase ventilation.
‹› With the Positive Crankcase Ventilation (PCV) heating element (N79).
‹› From the cylinder head cover.
14
Front Intake Manifold Support
15
Gasket
‹› Replace if damaged.
‹› Lightly lubricate with engine oil before installing and insert it into the upper intake manifold.
16
Gasket
‹› Replace
‹› Make sure it fits securely inside the lower intake manifold.
17
Lower Intake Manifold
‹› Removing and installing, refer to => [ Lower Intake Manifold, with Fuel Rail ] See: .
18
Fuel Rail
‹› For cylinders 2, 4 and 6.
‹› Fuel injector springs - item 23 - must be replaced before installing.
‹› Tighten uniformly, starting from the inside and working toward the outside.